Table of Contents
Advertisement
English
8.1. Programming addresses
You can set the decoder address either by programming the CVs with
your DCC central unit or by using the programming jumper or push-
button. When setting the decoder address it is of no importance if you
intend to operate the decoder by vehicle decoder commands
(locomotive commands) or accessory decoder commands (points
commands).
The accessory decoder address used to send the switching commands
result from:
Decoder address x 4
= highest address of the quadruple accessory decoder address block
When operating the decoder by locomotive addresses, you use the
function keys F1 to F4 to switch the connected accessories.
Name of CVs
Decoder address
1 to 63
Decoder address
(64 to 510)
Determining the input values for addresses higher
than 64:
1. Divide the chosen address by 64. Round down
the result to a whole number. Input this value in
CV#9.
2. Multiply the value set for CV#9 multiply by 64.
Subtract this result from the chosen address. Enter
this value in CV#1.
Page 26
CV-
Input value
no.
(Default)
1
1, 2, 3, ... 63
(1)
9
0, 1, 2, 3 ... 7
(0)
Remarks and tips
NB: In addition, you have to
input the value "0" in CV#9.
Please notice: You have to
input a value in CV#1 as well.
Example: address 415:
1. 415 / 64 = 6,5 à CV#9 = 6
2. 415 – (6 x 64) = 31 à CV#1 = 31
SD-34 | SD-34.2
Advertisement
Table of Contents
