Where To Add Light Oil Or Spray Lubrication; Grease The Idler Arms - Toro 74268CP Operator's Manual

Important: Make sure cutting unit spindles are
full of grease weekly.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the belt covers.
4. Grease the three spindle bearings under the pulleys
until grease comes out the lower seals (Figure 36).
5. Grease the idler arm on the mower deck (Figure 36).
6. Grease the fittings on the push arms (Figure 36).
Where to Add Light Oil or
Spray Lubrication
Service Interval: Every 150 hours
Lubricate the machine in the following areas with spray
type lubricant or light oil.
• Seat switch actuator.
• Brake handle pivot.
• Brake rod bushings.
• Motion control bronze bushings.
Figure 36

Grease the Idler Arms

1. Grease the cooling fan belt idler arm (Figure 37).
2. Grease the drive belt idler arms (Figure 37).
1. Left adjustable pulley
3. Grease the pump belt idler arm.
32
Figure 37
2. Back of the machine
Figure 38