Transport And Storage; Inspection; Transporting The Device; Storing The Device - ABB TTF300 Operating Instruction

24 TTF300 FIELD-MOUNT TEMPERATURE TRANSMITTER | OI/TTF300-EN REV. G
... 5 Product identification
... Name plate
Devices with combined types of protection may only be
operated in one of the possible types of protection.
Before commissioning, users must decide on one of these types
of protection and their corresponding approval.
• The 'E4' coding combines the following types of protection:
'Intrinsic safety', type 'TTF300-E1' and 'Flameproof
(enclosure)', type 'TTF300-E3'.
• The 'D6' coding combines the following types of protection:
'Intrinsic safety', type 'TTF300-E1' and 'Dust explosion
protection', type 'TTF300-D5'.
Additional combinations are generally possible.
Use in explosive hybrid mixtures (where explosive dusts and
gases are present simultaneously) is not currently permitted in
accordance with EN 60079-0 and EN 61241-0.
The additional plate has two checkboxes (see Figure 17) for
marking.
It is absolutely necessary to mark one of the checkboxes on the
left side indelibly in accordance with the selected type of
protection of the application. This has to be done before the
TTF300 is commissioned in the application.
The marking must be applied in a permanent and indelible
manner, for example by using a caustic or acidic pencil or by
stamping the marking on a metallic plate.
Unmarked devices must NOT be commissioned.

6 Transport and storage

Inspection

Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.

Transporting the device

Observe the following instructions:
• Do not expose the device to humidity during transport.
Pack the device accordingly.
• Pack the device so that it is protected against vibrations
during transport, for example, by using air-cushioned
packing.

Storing the device

Bear the following points in mind when storing devices:
• Store the device in its original packaging in a dry and
dust-free location.
• Observe the permitted ambient conditions for transport
and storage.
• Avoid storing the device in direct sunlight.
• In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in
the order confirmation of the supplier apply.

Ambient conditions

The ambient conditions for the transport and storage of the
device correspond to the ambient conditions for operation of
the device.
Adhere to the device data sheet!

Returning devices

For the return of devices, follow the instructions in Repair on
page 69.