Transport And Storage; Inspection; Transporting The Device; Storing The Device - ABB TTH300 Series Operating Instruction

TTH300 HEAD-MOUNT TEMPERATURE TRANSMITTER | OI/TTH300-EN REV. E
Figure 8: PROFIBUS PA name plate (example)
Figure 9: FOUNDATION Fieldbus name plate (example)
Devices with an explosion-proof design are marked with the
following special data plate.
1 Type designation in accordance
with approval
2 Type designation
3 Temperature class of the
explosion-proof design
Figure 10: Additional plate for explosion-protected apparatus (example)
Note
The name plates displayed are examples. The device
identification plates affixed to the device can differ from this
representation.
4 CE-mark (EU conformity) and
notified body for quality
assurance
5 Ex-marking
6 IP rating explosion-proof design

6 Transport and storage

Inspection

Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.

Transporting the device

Observe the following instructions:
• Do not expose the device to humidity during transport.
Pack the device accordingly.
• Pack the device so that it is protected against vibrations
during transport, for example, by using air-cushioned
packing.

Storing the device

Bear the following points in mind when storing devices:
• Store the device in its original packaging in a dry and
dust-free location.
• Observe the permitted ambient conditions for transport
and storage.
• Avoid storing the device in direct sunlight.
• In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in
the order confirmation of the supplier apply.

Ambient conditions

The ambient conditions for the transport and storage of the
device correspond to the ambient conditions for operation of
the device.
Adhere to the device data sheet!

Returning devices

For the return of devices, follow the instructions in Repair on
page 59.
17