DIODE LED AlphaTECH LED STRIP LIGHT Installation Manual page 6

INSTALLATION (CONT.)
5
ATTACH DRIVER AND LIGHTING
CONTROL.
OUTDOOR/UNDERWATER INSTALLATION
Using a pool/spa rated junction box, connect lead
wires from AlphaTECH
rated wires connected to power supply.
Verify a compatible driver is installed. Utilize
applicable wiring when installing outdoors. (Use of
wet location-rated junction box recommended)
6
TURN POWER ON AT CIRCUIT BREAKER
LED Strip Light INSTALLATION GUIDE
AlphaTECH
®
Strip Light to wet location
®
AlphaTECH
®
TROUBLESHOOTING
Shift in
brightness
and/or kelvin
Some LEDs
are not
functional
Lights are
flickering
Lights are
turning on/off
repeatedly
TOOLS & RESOURCES
AlphaTECH SPECIFICATION SHEET
®
For full specifications.
6 OF 8
LED STRIP LIGHT
INSTALLATION GUIDE
• Ensure an appropriate gauge of
wire is installed between strip light
and LED driver. See VOLTAGE
DROP CHARTS.
• Ensure strip light has not been bent
excessively, which could damage
circuitry.
• Ensure a compatible driver and/or
dimming control is installed. Check
for loose connections.
• Ensure driver is not overloaded. An
overloaded driver will trip the internal
auto-reset (of driver) repeatedly,
turning the system on/off.
IG121620-3.0