Table of Contents
Advertisement
Installation
4 4
Installation
4.1
Installation prerequisites
1.
2.
4.2
Installation procedure
•
4.2.1
Install the appliance
Safety conditions
Procedure
1.
2.
18
Make sure that the location agrees with the requirements. Refer to the preparation
manual.
Make sure that the details of the rating plate of the appliance agree with the gas type
and gas pressure of the gas supply.
Note:
The appliance is factory set to the correct nominal heat input. The pilot light is
set to the correct level of gas consumption.
Do all the procedures in this section. Optional procedures are indicated with
(optional).
Caution:
Do not install the appliance against a flammable rear wall.
Install the appliance. Make sure that
the distance C is approximately 2
cm.
Put a nonflammable insulation plate
(B) of at least 12 mm thick between
the appliance and the rear wall.
Make sure that the insulation plate
covers the entire area of the rear of
the appliance.
Smart Bell Panorama 45/59
Advertisement
Table of Contents
