Wireless Lan Connection Problems; Cannot Connect To The Mfp - Toshiba e-Studio2000AC Software Troubleshooting Manual

Wireless LAN Connection Problems

0.
 Cannot connect to the MFP
If you cannot establish a connection to the equipment, restart it
points:
 Is your user certificate (client certificate and CA certificate) valid?
 Are the access point and network settings correct?
 Select [WEP] or [None] from [Security] in infrastructure mode, and confirm that the touch panel indicates the status
of wireless LAN connection as "connected". If you still cannot establish the wireless LAN connection, the SSID or
WEP encryption key entered may be incorrect. Check the wireless LAN connection settings.
 When the encryption mode of the access point you are connecting is a TKIP mode, set the encryption mode of the
equipment to TKIP+AES.
 When the encryption mode of the access point you are connecting is a WPA mode, set the encryption mode of the
equipment to WPA/WPA2.
 When the encryption mode of the access point you are connecting is a WPAPSK mode, set the encryption mode of
the equipment to WPA/WPA2PSK.
 When you use both an infrastructure mode and a Wi-Fi Direct, set the same channel for both the wireless access
point as the connection destination in the infrastructure mode and the group owner in the Wi-Fi Direct.
 Is your wireless LAN disabled? The wired LAN and the infrastructure mode of wireless LAN cannot be used at the
same time.
* Press the [POWER] button to shut down the equipment, and then press the [POWER] button again.
*
. If the problem still persists, check the following

Wireless LAN Connection Problems 51