Table of Contents
Advertisement
Statement 26
1. Locate, record, and retain the product switch information in order to configure and
2. Attach a mounting bracket (Item 1) to each side of the switch with M4 screws
38
NE0152T Installation Guide
CAUTION:
Do not place any object on top of rack-mounted devices.
To install the NE0152T in a standard equipment rack, complete the following steps:
register your product. See
Note: If this switch is a replacement switch, copy the product information from the
original switch onto the RID label that is shipped with replacement switch and
affix the new label to the bottom of the new switch.
(Item 2). Torque the screws to approximately 2.0 newton-meters (Nm) ± 0.1 Nm
(17.7 inch-pounds).
"Before Installing the NE0152T" on page
1
32.
2
Advertisement
Table of Contents
