Removing the NE0152T from a Standard Equipment Rack
1. Disconnect all external cables.
2. If the air-duct option has been installed, remove it as described in
Air-Duct Option" on page
3. Loosen and remove M6 screws (Item 3) and clip nuts (or cage nuts - Item 4) to
release the switch unit from the rack. Slide the switch unit out of the rack.
4. Loosen and remove the M4 screws attaching the mounting bracket on each side of
the switch.
5. If replacing the unit with another NE0152T, see
© Copyright Lenovo 2018
This section describes how to remove the NE0152T from a standard 19-inch
equipment rack. For information about removing the switch from other supported
racks, see the appropriate section in this chapter.
To remove the NE0152T from a standard rack, complete the following steps:
3
69.
4
1
"Replacing the NE0152T" on page
Chapter 4: Removing and Replacing Components
"Removing the
2
70.
63