Using The Dcs-37-2 Mount (Optional) - D-Link DCS-4605EV User Manual

Vigilance 5 megapixel h.265 outdoor dome camera

Hide thumbs Also See for DCS-4605EV:

Table of Contents

Section 2: Installation

To mount the camera with the DCS-37-2 mount, follow the instructions below.

Step 1

Place the DCS-37-2 mounting sticker in the desired location, then use a 6 mm drill bit to drill

the required holes 25 mm deep and insert the wall anchors into the holes. If you plan to pass

cables through the ceiling, you will also need to drill a hole for the cable channel.

Note: The camera in the corresponding graphics may be different from your product, but the

procedure is the same.

Step 2

Use the provided screws to mount the DCS-37-2 to the wall using the inner mounting holes.

Step 3

Guide the camera connectors through the back or side cable channel on the DCS-37-2. Use

the provided screws to mount the camera to the DCS-37-2 using the set of mounting holes

marked B.

D-Link DCS-4605EV User Manual

Using the DCS-37-2 Mount (optional)

Table of Contents