Using The Dcs-37-1 Mount (Optional) - D-Link DCS-4802E User Manual

Section 2: Installation

Using the DCS-37-1 Mount (optional)

To mount the camera with the DCS-37-1 mount, follow the instructions below.
Step 1
Place the DCS-37-1 mounting sticker in the desired location, then use a 6 mm
drill bit to drill the required holes 25 mm deep and insert the wall anchors into
the holes. If you plan to pass cables through the wall, you will also need to drill
a hole for the cable channel.
Step 2
Use the provided screws to mount the DCS-37-1 to the wall.
Step 3
Remove the cover from the camera.
Pass the camera connectors through the back or bottom cable channel on the
DCS-37-1. Use the provided screws to mount the camera to the DCS-37-1 using
the set of mounting holes marked B.
D-Link DCS-4802E User Manual 11