Table of Contents
Advertisement
Section 2: Installation
It is highly recommended that you configure and test your camera before mounting it.
Step 1
Place the mounting sticker where you want to position the camera.
Use a 6 mm drill bit to make the required holes approximately 25 mm deep, then insert the
wall anchors into the holes.
Step 2
If you are running the camera cables through the wall, drill a hole in the center and pull
the cables through the hole.
Step 3
Use the included wrench to loosen the 4 screws on the top of the camera, then lift the camera
cover off.
D-Link DCS-4605EV User Manual
Installation
Mounting the Camera
9
Advertisement
Table of Contents
