Cisco Nexus 9504 Hardware Installation Manual page 79

Nx-os mode switch

Hide thumbs Also See for Nexus 9504:

Table of Contents

Replacing or Installing Modules, Fan Trays, and Power Supplies

• If you are replacing a fan tray, open the packaging for the new fan tray and inspect it for damage. If the

Step 1

Unscrew the four captive screws on the front of the fan tray (one on each corner of the front of the fan tray) until each

screw is free of the chassis (see Callout 1 in the following figure).

Figure 13: Removing a Fan Tray from the Chassis

Unscrew four captive screws (two at the top of the

module and two at the bottom of the module).

Hold the two fan tray handles with your two hands.

Step 2

Hold both handles on the front of the fan tray with both of your hands and pull the fan tray out of the slot.

Step 3

Set the fan tray on antistatic material or inside an antistatic bag.

module is damaged, contact the Technical Assistance Center (TAC) and wait until you have an undamaged

fan tray to install.

Pull on the fan tray to slide it out of the chassis. Set

the fan tray on an antistatic surface.

Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide

Removing a Fan Tray

Table of Contents