Assign Relay To A Stage; 3.6.10 Assigned Sp Signal To Analog Output - Intec MGC2-12 User Manual

PolyGard Multi-Point Controller
®
User Manual - MGC2-12
3.6.9

Assign Relay to a Stage

Any of the 15 Relays can be assigned freely to any Stage. Stages that do not activate relays receive an
assignment of 00.
Symbol Description
SP 01 Sensor Point
S1
S2
1 S3
S4
S5

3.6.10 Assigned SP Signal to Analog Output

The sensor point signal can be assigned to one of the six analog Outputs. The signal defined in the control
mode (Current Value or Average Value) is transmitted.
Analog output see also: 3.7.2
Symbol Description
SP 01 Sensor Point
0 A
Polygard® is a registered trademark of MSR
Customer Services (858) 578-7887 & (888) GO INTEC
INTEC Controls, 12700 Stowe Dr., Suite 100, Poway, CA 92064
Default
Function
Status
Selection SP No.
01 01 = Stage 1 activate relay R 01
02 02 = Stage 2 activate relay R 02
03 03 = Stage 3 activate relay R 03
00 00 = Stage 4 does not activate a relay
05 05 = Stage 5 activate relay R 15 (internal horn)
Default
Function
Status
Selection SP No.
0 = SP Signal not assigned to any analog output
0 1 = SP Signal assigned to analog output 1
X = SP Signal assigned to analog output X
Fax (858) 578-4633 & (888) FX INTEC
www.inteccontrols.com
Page 18
Specification subject to change without notice.
Printed in USA 131119
MGC2-12