Table of Contents
Advertisement
PolyGard
Multi-Point Controller
®
User Manual - MGC2-12
8
Notes and General Information
It is important to read this user manual thoroughly and clearly understand the information and instructions. The
®
PolyGard
MGC2 monitoring, control and alarm system must be used within product specification capabilities. The
appropriate operating and maintenance instructions and recommendations must be followed.
Due to ongoing product development, MSR reserves the right to change specifications without notice. The
information contained herein is based upon data considered to be accurate. However, no guarantee is expressed
or implied regarding the accuracy of this data.
8.1
Intended product application
®
The PolyGard
MGC2 are designed and manufactured for control applications for energy savings and OSHA
air quality compliance in commercial buildings and manufacturing plants (i.e., detection and automatic exhaust
fan control for automotive maintenance facilities, enclosed parking garages, engine repair shops, warehouses
with forklifts, fire stations, tunnels, etc.).
8.2
Installers' responsibilities
It is the installer's responsibility to ensure that all PolyGard
and local codes and OSHA requirements. Installation should be implemented only by individuals familiar with
proper installation techniques and with codes, standards and proper safety procedures for control installations
and the latest edition of the National Electrical Code (ANSI/NFPA70). It is also essential to strictly follow all
instructions as provided in the user manual.
8.3
Maintenance
It is recommended that the PolyGard
performance deviations may be serviced based on needed requirements. Part replacement may be
implemented in the field by a qualified individual and with the appropriate tools.
8.4
Limited warranty
MSR-Electronic-GmbH and INTEC Controls warrants the PolyGard
date of shipment against defects in material or workmanship. Should any evidence of defects in material or
workmanship occur during the warranty period, INTEC Controls will repair or replace the product at their own
discretion, without charge.
This warranty does not apply to units that have been altered, had attempted repair, or been subject to abuse,
accidental or otherwise. The above warranty is in lieu of all other express warranties, obligations or liabilities.
This warranty applies only to the PolyGard
liable for any incidental or consequential damages arising out of or related to the use of the PolyGard
If the PolyGard
MGC2 needs to be returned to INTEC Controls for service, an RMA number must be obtained
®
prior to sending.
Polygard® is a registered trademark of MSR
Customer Services (858) 578-7887 & (888) GO INTEC
INTEC Controls, 12700 Stowe Dr., Suite 100, Poway, CA 92064
®
MGC2 are installed in compliance with all national
®
MGC2 performance check is done on a routine schedule. Any
MGC2. MSR-Electronic-GmbH and/or INTEC Controls shall not be
®
Fax (858) 578-4633 & (888) FX INTEC
www.inteccontrols.com
Page 34
MGC2 for a period of two years from the
®
Specification subject to change without notice.
MGC2.
®
MGC2-12
Printed in USA 131119
Advertisement
Table of Contents
