Assigned Stage To Relay; 3.6.10 Assigned Sp Signal To Analog Output; Menu System Setup - Intec PolyGard LGC/LG2-04 User Manual

PolyGard Multi-Point Controller
®
User Manual - LGC/LG2-04
LGC-LG2 – UserManual
LGC-LG2 – UserManual LGC-LG2 – UserManual
3.6.9

Assigned Stage to Relay

Each of the 5 alarms can be assigned to a freely selectable alarm relay.
receive assignment.
Symbol Description
SP 01 Sensor Point
A1
A2
1 A3
A4
A5
0 A

3.6.10 Assigned SP Signal to analog Output

The sensor point signal can be assigned to one of the two analog Outputs. The signal defined in the control
mode (current or average value) is transmitted. The assignment occurs in the menu „assignment alarm < > alarm
relay" in the right place.
Analog output see also: 3.7.2
3.7

Menu System Setup

Display and change the System Parameters for the Controller
System Setup
Service Mode
OFF
Software Version
GC02- XX
Next maint. Date
TT.MM.JJ
Service Phone
858 578-7887
AV Overlay
0 s.
AV Time
1800 s
Time system
US
Polygard® is a registered trademark of MSR
Customer Services (858) 578-7887 & (888) GO INTEC
INTEC Controls, 12700 Stowe Dr., Suite 100, Poway, CA 92064
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | relevantsolutions.com/inteccontrols 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | relevantsolutions.com/inteccontrols
Specifications subject to change without notice. | USA 200211 | Page 17 of 30
Specifications subject to change without notice. | USA 160104 | Page 17 of 30 Specifications subject to change without notice. | USA 131119 | Page 17 of 30
Default
Function
Status
Selection SP No.
01 01 = Stage 1 activate relay R 01
02 02 = Stage 2 activate relay R 02
03 03 = Stage 3 activate relay R 03
04 04 = Stage 4 activate relay R 04
00 00 = Stage 5 does not activate any relay
0 = SP Signal not assigned to any analog output
0 1 = SP Signal assigned to analog output 1
X = SP Signal assigned to analog output
(Main Menu)
See 3.7.1
See 3.7.2
See 3.7.3
See 3.7.3
See 3.7.4
120 ppm
See 3.7.4
See 3.7.5
Fax (858) 578-4633 & (888) FX INTEC
Alarms, those not to be needed do not
PolyGard is a registered trademark of MSR-Electronic GmbH | LGC/LG2-04 Polygard® is a registered trademark of MSR | LGC/LG2-04
®
Specification subject to change without notice.
www.inteccontrols.com
Page 17
X
LGC/LG2-04
Printed in USA 131119