Table of Contents
Advertisement
The RMNs for these switches are listed below. These RMNs should not be confused with the
marketing names HP 5130 EI, or product numbers JG942A, JG943A, JG944A, JG946A and
JG947A.
Product code
JG942A
JG943A
JG944A
JG946A
JG947A
Safety recommendations
To avoid equipment damage or bodily injury, read the following safety recommendations before
installation. Note that the recommendations do not cover every possible hazardous condition.
Before cleaning the switch, remove all power cords from the switch. Do not clean the switch with wet
•
cloth or liquid.
Do not place the switch near water or in a damp environment. Prevent water or moisture from
•
entering the switch chassis.
Do not place the switch on an unstable case or desk.
•
•
Ensure good ventilation at the installation site and keep the air inlet and outlet vents of the switch
free of obstruction.
Connect the yellow-green protection grounding cable before power-on.
•
Make sure the power source voltage is as required.
•
•
To avoid electrical shocks, do not open the chassis while the switch is operating or when the switch
is just powered off.
To avoid ESD damage, wear an ESD wrist strap to hot-swap a power supply.
•
Examining the installation site
The HP 5130 EI switches must be used indoors. You can mount your switch in a rack or on a workbench,
but make sure:
Adequate clearance is reserved at the air inlet and exhaust vents for ventilation.
•
The rack or workbench has a good ventilation system.
•
•
The rack is sturdy enough to support the switch and its accessories.
The rack or workbench is well grounded.
•
To ensure correct operation and long service life of your switch, install it in an environment that meets the
requirements described in the following subsections.
Temperature/humidity
Maintain temperature and humidity in the equipment room as described in
RMN
HP description
BJNGA-AD0027
HP 5130-24G-4SFP+ EI TAA-compliant Switch
BJNGA-AD0028
HP 5130-24G-SFP-4SFP+ EI TAA-compliant Switch
BJNGA-AD0029
HP 5130-48G-4SFP+ EI TAA-compliant Switch
BJNGA-AD0031
HP 5130-24G-PoE+-4SFP+ (370W) EI TAA-compliant Switch
BJNGA-AD0032
HP 5130-48G-PoE+-4SFP+ (370W) EI TAA-compliant Switch
4
"Technical
specifications."
Hide quick links:
Advertisement
Table of Contents
