Internet: www.fetco.com Versions The TBS-21A is available in two versions, determined by the software and the start switch configuration: Iced Tea Only version – Start switch is selectable between “FULL” or “HALF” batches. Iced Tea / Coffee version – Start switch is selectable between “ICED TEA” or “COFFEE”.
Verify that the water line will provide at least 1.5 gallons per minute General: Utilize only qualified beverage equipment service technicians for installation. A Service Company Directory may be found on our web site, http://www.fetco.com. Installation Instructions Brewer Setup 1. Review the Dimensions for the unit you are installing. Verify that the brewer will fit in the space intended for it, and that the counter or table will support the total weight of the brewer and dispenser when filled.
Page 5
Final Setup 1. Turn on the incoming water supply line and inspect both inside and outside of the brewer for leaks in all fittings and tubes 2. Turn on the incoming power. 3. Turn on the brewer’s main power switch. 4.
1. Turn brewer power switch to the on position • The power switch will illuminate to indicate that the brewer has power and is operational. • When the ready light illuminates, the brewer is fully up to temperature. The amount of time required to gain full operating temperature will vary depending on voltage and the temperature of the incoming water.
Turn the power switch off. Remove the control board cover, located behind the dispenser. Turn the power switch on. Hold the SET button for 5 seconds, until the display reads SET. Next, the display will show the software version Press SET. The first parameter number will be displayed briefly, followed by the current setting.
Relay Test Tests the individual relays which control various components. Use the UP or Down button to actuate the relays. Fill Valve Dilution Valve Brew Valve Ready Light Brew Light Heater Triac Error Codes 001 Software - System Reloaded Defaults 003 Internal CPU or Board Error 050* Shorted Temperature Probe 051* Open Temperature Probe...
Brewer Daily: Wipe the area above the brew basket to remove coffee and tea residue. Daily or Weekly: The spray plate should be removed and cleaned to remove hard water deposits. In areas with extremely hard water, it may be necessary to do this daily. Weekly cleaning may be sufficient in some areas.
ITD-30 Dispenser Product Number D031 ITEM PART NO. DESCRIPTION 23088 COVER, ITD-30 23089 HANDLE 23087 LINER, ITD-30 85025 SPRING, COMPRESSION 102204 FAUCET, COMPLETE 23090 PLUG 71088 FAUCET UPPER ASSY., BLACK HANDLE 71028 FAUCET HANDLE, BLACK 71035 FAUCET SEAT CUP 102199 FAUCET HOUSING ASSY. 84029 HEX NUT, 5/16-18 S.S.
Page 13
Airpot & Stand (Iced Tea / Coffee Version) Product Number D041 3.0 Liter Stainless Steel Lined Lever Airpot Replacement Parts PART # DESCRIPTION 71082 LID, LEVER TYPE 99024 TUBE ASSY. Product Number A095 Airpot Brewing Stand...