Motion - Wirepath WPS-365-DVR Installation And User Manual

WPS-365-DVR-9CH & 16CH Installation and Users Manual
• EVENT RECORD FPS
Set the Frames Per Second Record rate for each camera when events such as motion or alarm inputs
trigger the camera to record. Settings for Post Record time determines how long the DVR will record
after the event triggers recording. Please refer to Section 9.3.6 and Section 9.3.9 for Post-record time.
Select a value from 0 (off) - 30.
Note: The total Event Record FPS should not exceed the system recording capacity of 270 FPS (9CH) or
480 FPS (16CH) FPS at CIF resolution, 240 FPS at Half-D1 resolution or 120 FPS at Full-D1 resolution as set in
Pre-Camera setup in Section 9.3.4. Check the system's total Event Record FPS by adding each camera
connected to the system's individual FPS.. The DVR will automatically lower the actual record rate if set
beyond the system's capabilities once the total maximum FPS is reached.
Recommendation: The higher the FPS setting for a camera, the more fluid the motion on playback.
A slower FPS setting could result in "choppy" video during playback, As a reference, live video equals
30 FPS. In surveillance, 15 FPS is recognized as very good quality video while 7 FPS is typically sufficient
for most cases.
• PRE-RECORD FPS
The Frames Per Second Pre-Record rate for each camera when events such as motion, video loss or alarm
inputs trigger the camera to record. Settings for Pre-Record determine how much time the DVR will record
before the event triggers recording. Please refer to Section 9.3.6, Section 9.3.8, and Section 9.3.9 for Pre-
record time.
• NORMAL RECORD FPS
Unless disabled in the schedule (see Section 9.3.11), or this setting is set to 0 the DVR is always recording.
If there is no event triggering the DVR to record (such as motion or alarm inputs), the recording is referred
to as Normal Record. Set the FPS for each camera to be recorded at from a minimum of 0 (off) to a
maximum equal to the Event Record setting.
9.3.6.

MOTION

Motion Setup allows the administrator to define how the system responds when motion is detected for
the camera. Use the OSD from the VGA, HDMI or BNC main monitor outputs to define the motion detection
area (See Section 6.2.2).
96