Table of Contents
Advertisement
WPS-365-DVR-9CH & 16CH Installation and Users Manual
DVR Front Panel
and Remote
Function
Operations
Focus
Iris
Auto Pan (3)
SEQ/Tour Mode
+/-, NUMBER
(5 sec.)
+/-, NUMBER
Preset (1)
Pan Speed (3)
7.1. OSD CONTROL FOR WIREPATH™ SURVEILLANCE CAMERAS
Wirepath™ Surveillance Series Analog Cameras offer remote control of the OSD (On Screen Display) menu.
This is achieved through the PTZ functions of the DVR. The cameras must be connected to the RS-485 terminals
on the DVR and properly configured according to the camera manual. The DVR must also be properly
configured. Please refer to Section 3.2.2 Optional Connections for the connections, Section 6.1 Pre-Camera
Setup to set the PTZ ID of each PTZ camera, and Section 6.10 RS-232/422/485 Setup to setup the RS-485 control
port.
64
Mouse Operation
Control
+/-
ENTER
+/-
+/-
ENTER
*
#
ENTER
ENTER
+/-
Descriptions
• Use the +/- buttons to focus far/near
• Press the ENTER button to auto focus
• Use the +/- buttons to increase/
decrease the Iris
• The Iris + button is used to access the
OSD control of Wirepath™ Surveillance
cameras and to confirm (enter)
commands
Auto pan speed is shown in parenthesis
• Use the +/- buttons to increase/
decrease speed
• Press Enter start/stop Auto Pan
*
• Press (
) set start position
• Press (#) set end position
SEQ dwell time is shown in parenthesis
• If SEQ mode is on, the camera will go to
preset position 0-9 (or 1-10) sequentially.
• Use the +/- and the Number buttons
to change dwell time
• Press the ENTER button to start/stop
SEQ mode
*
• An asterisk (
) will be shown if SEQ
mode is on
Preset location is shown in parenthesis
• Use the +/- and the Number buttons
to change Preset location
• Set Preset location
Manual pan speed is shown in parenthesis
• Use the +/- buttons to increase/
decrease speed
Advertisement
Table of Contents
