Table of Contents
Advertisement
WPS-365-DVR-9CH & 16CH Installation and Users Manual
5.4. DISPLAY
The VGA Display menus allows for adjustment to the VGA and HDMI output of the DVR.
Once in the Main Menu display, press ▲▼◄► on the front panel of the DVR or remote control to select VGA
Display and then press ENTER to display the menu as shown. Alternatively use the mouse to click on the VGA
Display icon.
Use the operations listed below to adjust Resolution, Brightness, Contrast, Hue, Saturation and Video Ratio.
To set Video Ratio, select between Fit Window and Proportion. Fit Window scales all camera channels to fill the
grids. Proportion allows each camera to be displayed using its output video ratio.
Warning – Be sure the connected VGA or HDMI monitor can accept the desired resolution before selecting it. If
a resolution is selected that is not supported by the monitor and video is lost at the VGA monitor, continue to
use the +/- buttons on the front panel of the DVR or the remote control to select a setting that is supported.
Another option would be to temporarily connect a composite video monitor to the Video Out BNC to
properly set the VGA resolution.
• ▲▼◄►
Press these buttons on the front panel of the DVR or remote control to select an item. Alternatively
use the mouse to select an item.
• +/-
Press these buttons on the front panel of the DVR or remote control to change the settings. Alternatively
use the mouse to make these changes.
• NUMERIC
Press these buttons on the front panel of the DVR or remote control to change the camera. Alternatively
use the mouse to select the desired camera.
• MODE
Press this button on the front panel of the DVR or remote control to restore Brightness, Contrast, Hue and
Saturation values. Alternatively use the mouse to click on the Factory Reset button.
• ESC
Press the ESC button on the front panel of the DVR or remote control to escape from this menu and
return to the main Menu display. Alternatively use the mouse to exit the sub menu by clicking on the "X."
If the contents in this menu have been modified, a Save dialog box will be displayed requesting the user
to save the changes. Press ENTER on the front panel of the DVR or remote control to exit and save, ESC to
exit without saving. Another method to escape is to use the mouse to "right-click," and exit the sub menu.
23
Advertisement
Table of Contents
