Yamaha FJR1300N 2001 Service Manual page 77

Part to be tightened
Thermostat assembly
Thermostat housing cover
Water pump
Water pump housing cover
Coolant drain bolt
Muffler joint
Muffler
Exhaust pipe
Exhaust pipe
Exhaust check bolt
O sensor
2
Starter motor
NOTE:
*1:Tighten the cylinder head bolts to 25 Nm (2.5 m • kg) in the proper tightening sequence, loosen
and retighten the cylinder head bolts to 25 Nm (2.5 m • kg) in the proper tightening sequence,
and then tighten the cylinder head bolts further to reach the specified angle 180° in the proper
tightening sequence.
*2:Tighten the crankcase bolts to 20 Nm (2.0 m • kg) in the proper tightening sequence, loosen and
retighten the crankcase bolts to 20 Nm (2.0 m • kg) in the proper tightening sequence, and then
tighten the crankcase bolts further to reach the specified angle 120° in the proper tightening
sequence.
*3:Tighten the connecting rod nuts to 20 Nm (2.0 m • kg), and then tighten the connecting rod nuts
further to reach the specified angle 120°.
TIGHTENING TORQUES
Thread
Part name
size
Torx screw M6
Bolt M6
Bolt M6
Bolt M6
— M6
Bolt M8
Bolt M10
Nut M8
Bolt M8
— M6
— M18
Bolt M6
2 - 21
SPEC
Tightening
torque
Q'ty
Nm m·kgf
1 10 1.0
2 10 1.0
3 12 1.2
1 10 1.0
1 10 1.0
2 20 2.0
2 25 2.5
8 20 2.0
2 17 1.7
4 10 1.0
1 45 4.5
2 10 1.0
Remarks