Yamaha FJR1300N 2001 Service Manual page 609

Installing Riv-Nut ports in the FJR's Headers
This is a riv-nut tool. Similar to a standard pop rivet gun, but with
interchangeable adapters and anvils sized for the insert being installed. The
appropriate adapter is screwed into the tool, followed by the corresponding anvil.
In use the riv-nut is threaded onto the adapter, inserted into the hole, and
compressed against the anvil when the handle is squeezed to draw the adapter
inwards. After installation, the removal knob is turned counter-clockwise to
unscrew the adapter from the insert.
http://www.micapeak.com/bike/FJR1300/howto/rivnut.html (2 of 10) [15/05/2003 5:56:43 PM]