Yamaha FJR1300N 2001 Service Manual page 341

CYLINDER HEAD
d. Loosen and retighten the cylinder head
bolts in the proper tightening sequence as
shown.
Cylinder head bolt (M10)
2nd
25 Nm (2.5 m · kg)
e. Tighten the cylinder head bolts further to
reach the specified angle 180° in the proper
tightening sequence as shown.
Cylinder head bolt (M10)
Final
Specified angle 180°
WARNING
When the bolts are tightened more than the
specified angle, do not loosen the bolt and
then retighten it.
Replace the bolt with a new one and per-
form the procedure again.
CAUTION:
• Do not use a torque wrench to tighten the
bolt to the specified angle.
• Tighten the bolt until it is at the specified
angle.
NOTE:
When using a hexagonal bolt, note that the
angle from one corner to another is 60°.
5 - 22
ENG