Yamaha FJR1300N 2001 Service Manual page 396

MIDDLE GEAR
NOTE:
@
• Tighten the middle driven shaft bearing
housing bolts carefully, one thread turn at a
time only. Push in the middle driven shaft
bearing housing and then tighten the bolts to
specification.
• Clearance between the crankcase and the
middle driven shaft bearing housing should
be approximately 2 mm, when measured
with a thickness gauge 1.
4. Hold the middle drive shaft 1.
5. Turn:
• middle driven shaft
NOTE:
@
While carefully tightening the middle driven
shaft bearing housing bolts in stages and in a
crisscross pattern, turn the middle driven shaft
back and forth until the dial gauge reads 0.10 ~
0.20 mm.
6. Measure:
• crankcase-to-middle-driven-shaft-bearing-
housing clearance
(with a thickness gauge)
5 - 77
ENG