Connection For Dr-1Xe - Yaesu DR-1X Operating Manual

Connection for DR-1XE

Follow the outline in the illustration regarding the proper connection of the DC power cable.
The DC power connector for the DR-1XE must only be connected to a DC source providing 13.8 V DC (±15 %), and capable of at
least 10 A of current.
Always observe proper polarity when making DC connection.
Caution
z Make sure to switch OFF the power of the external power source before connecting.
1
Insert the socket of the provided DC power cord to the DC IN jack at the rear of the repeater
2
Connect the red wire (+) of the provided DC power cord to the positive (+) terminal of the external power source, and the black
wire (-) to the negative (-) terminal
–
(black)
Tip
The external power source should be installed near the equipment and should be easily accessible.
Permanent damage can result when improper supply voltage, or reverse-polarity voltage, is applied to the DR-1XE. The
Limited Warranty on this radio does not cover damage caused by application of AC voltage, reverse polarity DC, or DC
voltage outside the specified range of 13.8 V ±15 %. When replacing fuses, be certain to use a fuse of the proper rating.
The DR-1XE requires a 15 A blade fuse.
Fuse (15 A)
+
(red)
Connecting the Power Supply
15