the last menu or let the unit idle one minute to exit menu mode.
7.3 Address Setting
If you use a universal DMX controller to control the units, you have to set DMX address
from 1 to 512 so that the units can receive DMX signal.
Press MENU button to enter menu mode, select DMX Settings, press ENTER button to
confirm, use UP/DOWN button to select DMX Address, press ENTER button to confirm,
the present address will blink on the display, use UP/DOWN button to adjust the address
from 1 to 512, press ENTER button to store. Press MENU button back to the last menu or
let the unit idle one minute to exit menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel mode
54 channels
29 channels
7.4 DMX 512 Configuration
Please refer to below configurations to control the fixtures
Attention:
1. The unit will remain the last condition if the DMX signal is cut-off.
2. For the channel function, when you change the value from 0~255 very quickly, keep the
value for about 5 seconds, then the corresponding function will take into effect.
3. Total three Layers of images.
- Layer one: Works as Background function.
- Layer two: Works as Shelter function of the background of layer one.
- Layer three: Works as Transparent function. (You can see layer one/two through the
black part of picture of layer 3.)
Unit 1
Unit 2
Address
Address
1
55
1
30
DVS-2500/5000/5000II
Unit 3
Unit 4
Address
Address
109
163
59
88
30B