Cautions On Wireless Module Installation; Procedure - Panasonic PT-FW430E Operating Instructions Manual

Cautions on Wireless Module Installation

Cautions on Wireless Module Installation
The optional Wireless Module (part number ET-WM200E) is required to use wireless
LAN functions.
Before installing the wireless module to the projector, remove the protective sticker
and cap from the wireless module.

Procedure

1 ) Use a Phillips screwdriver to loosen the
Wireless Module cover screw until it
turns freely. Then, remove the Wireless
Module cover.
Remove the Wireless Module cover by moving it
z
in the direction of the arrow.
2 ) Face the LED lamp of the Wireless
Module upward, and insert the Wireless
Module into the Wireless Module
connection terminal.
3 ) Attach the Wireless Module cover to
the projector and tighten the Wireless
Module cover screw using a Phillips
screwdriver.
Place the Wireless Module cover from the top
z
and slide it in.
Attention
Keep the small parts out of the reach of small children.
z
Tighten screws using a torque screwdriver or others. Do not use an electric screwdriver or an impact
z
screwdriver.
The serial number of accessories and optional parts is subject to change without notice.
z
Do not insert wireless module other than the optional ET-WM200E.
z
72
- ENGLISH
Wireless Module cover
Wireless
Module
connection
terminal
LED lamp
Wireless Module cover
fixing screw