TEMP, LAMP and FILTER Indicators
TEMP, LAMP and FILTER Indicators
Managing the indicated problems
If a problem should occur inside the projector, the TEMP, LAMP and/or FILTER indicators will inform you. Manage
the indicated problems as follow.
CAUTION
Before you take a remedial measure, follow the procedure of switching the power off indicated in "Powering off the
z
projector". (
Æ
page 28)
If multiple indicators light or blink, verify the status of the projector by looking at each indicator.
z
Note
z Confirm the status of the power
indicated on the POWER indicator.
LAMP indicator
J
Indicator
Lighting in red
Indicates the time to replace
the lamp unit. Lights when
Status
the duration of the lamp unit
exceeds 5800 hours.
Is a message to recommend
replacing lamp unit displayed
Check
on screen after turning the
power on?
Replace the lamp unit.
Remedy
(
Æ
Note
Contact your dealer for repair services when <Lamp indicator> persists to light or flash after taking these measurements.
z
When the setting of [HIGH ALTITUDE MODE] to [OFF] at an elevation of 1400 m (4593 ft) or more, the life of the lamp unit
z
becomes shorter.
66
- ENGLISH
POWER indicator
page 70)
LAMP indicator
ON (G)
LAMP
TEMP
STANDBY (R)
Blinking in red
Luminous lamp does not light or ceases lighting during
operation.
Have you turned the power
back on immediately after the
power had been turned off?
Does power outage occur?
Wait for 90 seconds or longer
to let the luminous lamp
become cooler. Then, turn the
power on.
TEMP indicator
FILTER indicator
FILTER
Turn off the power. And turn
the power back on again.
Turn off the power in
accordance with "Powering off
the projector" (
page 28) and
Æ
consult your dealer.