Projection Method; High Altitude Mode; Lamp Power - Panasonic PT-FW430E Operating Instructions Manual

PROJECTION METHOD

A projection scheme can be chosen depending on
the installation of the projector. If the picture is shown
upside down or in reverse, change the projection
method.
1 ) Press ▲▼ to select [PROJECTION
METHOD].
2 ) Press ◄► to switch [PROJECTION
METHOD].
Each press of the button switches the settings
z
as shown below.
FRONT/DESK
REAR/CEILING
Setting on a desk/floor in front of the
FRONT/DESK
screen and projecting forward
Mounting on a ceiling using the
FRONT/ ceiling mount bracket (option) in
CEILING front of the screen and projecting
forward
Setting on a desk/floor behind the
REAR/DESK
screen and projecting from behind
Mounting on a ceiling using the
REAR/ ceiling mount bracket (option)
CEILING behind the screen and projecting
from behind

HIGH ALTITUDE MODE

If you use the projector at elevations (1 400 m (4593
ft) to 2 700 m (8858 ft)), the [HIGH ALTITUDE MODE]
setting needs to be [ON].
1 ) Press ▲▼ to select [HIGH ALTITUDE
MODE].
2 ) Press ◄► to switch [HIGH ALTITUDE
MODE].
Each press of the button switches the settings
z
as shown below.
OFF
Select this when using in normal
OFF environment (lower than 1 400 m
(4593 ft) above sea level)
Select this when using at high
altitude (1400 m (4593 ft) or higher
ON
and lower than 2700 m (8858 ft)
above sea level)
FRONT/CEILING
Can switch the electric power of projector lamp. Set
REAR/DESK
the lamp power to meet the environment and purpose
of projection.
1 )
2 )
ON
PROJECTOR SETUP menu
Note
Make sure to set this to [OFF] when you use the
z
projector at elevations lower than 1400 m (4593 ft) above
sea level. Set this to [ON] when you use the projector
at elevations of 1400 m (4593 ft) or higher and lower
than 2700 m (8858 ft). Failure to observe this may result
in shortening of the life of units or malfunction of the
projector.
Do not install the projector at elevations of 2700 m (8858
z
ft) or higher. Doing so may result in shortening of the life
of units or malfunction of the projector.
The loudness of fan noise depends on the [HIGH
z
ALTITUDE MODE] setting.

LAMP POWER

Press ▲▼ to select [LAMP POWER].
Press ◄► to switch [LAMP POWER].
The setting will change as follows each time the
z
button is pressed.
NORMAL
NORMAL When high brightness is needed
ECO When high brightness is not needed
Note
The [ECO] mode can reduce power consumption and
z
operation noise.
The selection made here is reflected to the indication of
z
set ECO level in the "Multi Projector Monitoring & Control
Software" installed from the supplied CD-ROM.
ECO
55
ENGLISH -