Schedule - Panasonic PT-FW430E Operating Instructions Manual

PROJECTOR SETUP menu

SCHEDULE

This sets the command execution schedule for each
day of the week.
How to enable the SCHEDULE
J
function
1 ) Press ▲▼ to select [SCHEDULE].
2 ) Press ◄► to switch [SCHEDULE].
Each press of the button switches the settings
z
as shown below.
ON
ON Enables set SCHEDULE
OFF Disable set SCHEDULE
Note
If [SCHEDULE] is set to [ON], the setting for [STANDBY
z
MODE] is automatically set to [NORMAL] and cannot be
changed. Even if [SCHEDULE] is then set to [OFF] when
in this state, the setting of [STANDBY MODE] remains at
[NORMAL].
How to assign a program
J
1 ) With [SCHEDULE] switched to [ON],
press <ENTER> button.
The [SCHEDULE] screen will be displayed.
z
2 ) Select and assign program to each day
of week.
Press ▲▼ to select a day of week and press
z
◄► to select a program number.
You can set the program from No.1 to No.7.
z
"- - -" indicates that the program number has
not been set yet.
56
- ENGLISH
How to set a program
J
You can set up to 16 commands to each program.
1 ) On the [SCHEDULE] screen, press ▲▼
to select [PROGRAM EDIT].
2 ) Press ◄► to select a program number
to be set (Program 1 to Program 7) and
press the <ENTER> button.
3 ) Press ▲▼ to select a command
number (01 to 16) and press the
<ENTER> button.
You can change the page using ▲▼.
z
OFF
4 ) Press ▲▼ to select [TIME] or
[COMMAND] and change the setting
according to the instructions of the
menu.
Press the <ENTER> button after selecting the
z
[COMMAND], and you can set detailed settings.
TIME
COMMAND
*1 : PT-FW430E only
5 ) Press ▲▼ to select [STORE] and
press the <ENTER> button.
Note
If you try to register a setting that would cause the lamp to
z
flash for a short time, an error message will be displayed on
the screen. Set the [TIME] and [COMMAND] again.
If multiple commands have been set for the same time,
z
they are executed in chronological order starting from the
smallest command number.
The setting time operates under the local time.
z
Æ
( page 60)
If an operation is executed with the remote control or
z
control panel of the projector or with a control command
before the command set in the schedule is executed, the
command set with this function may not be executed.
Set the time at which the command
will be executed using ▲▼ buttons.
Select a command to execute at the
set time from the following.
• POWER ON • SIDE BY SIDE
STANDBY MODE OFF*
•
• AV MUTE ON • SIDE BY SIDE
• AV MUTE OFF MODE ON*
• INPUT • IN STANDBY
COMPUTER MODE (AUDIO)
• INPUT VIDEO ON
INPUT S-VIDEO IN STANDBY
• •
INPUT DVI-I MODE (AUDIO)
•
• INPUT HDMI OFF
• INPUT • VOLUME
NETWORK
• LAMP POWER
NORMAL
LAMP POWER
•
ECO
1
1