Powering Off The Projector; Direct Power Off Function - Panasonic PT-FW430E Operating Instructions Manual

Powering ON/OFF

Powering off the projector

1) 2)
1 ) Press the POWER (
The "POWER OFF" confirmation screen appears.
Pressing any button other than the POWER
z
( ) button or leaving the projector idle for
10 seconds will clear the "POWER OFF"
confirmation screen.
2 ) Pressing the POWER (
again will turn off the lamp, a beep
sound will be heard and projection
stops.
The cooling fan will continue turning and the
z
<Power indicator> will light orange. Wait until
the <Power indicator> turns red.
When [STANDBY MODE] is set to [NORMAL],
z
the <Power indicator> will blink red.
Use the onscreen menu to turn the beep that
z
is heard when pressing the POWER (
button to [ON] or [OFF].
3 ) When the <Power indicator> is red,
set the <MAIN POWER> switch to
[OFF] to turn the projector off.
Note
Do not turn on the power immediately after turning it
z
off.
The lamp may not light when you turn on the power
while the luminous lamp is in cooling state after the
power is turned off. Turn the power on after the <Power
indicator> lights in red. If you turn the power on while the
temperature of the lamp is high, it may shorten the lamp
life.
The projector consumes power when you turn off the
z
projector pressing [OFF] on the remote control while the
<MAIN POWER> of the projector is [ON]. For details on
power consumption, see "Power consumption" in the
"Specifications". (
Æ
In the [SECURITY] menu, check that [CONTROL
z
PANEL] (when operating from the projector) or [REMOTE
CONTROLLER] (when using the remote control) in the
[CONTROL DEVICE SETUP] is set to [ENABLE].
( Æ page 64)
28
- ENGLISH
1) 2)
) button.
) button
page 83)
3)

Direct power off function

Even if you turn the <MAIN POWER> switch [OFF]
during projection or just after the lamp turns off, the
cooling fan will continue to rotate using internally
stored power. In cases where the <MAIN POWER>
switch is not easily accessible, such as during ceiling
mount, you can safely turn off the power by using
the power breaker switch. This function also works
if a power outage occurs or if the power cable is
accidentally disconnected from the outlet right after
turning the power off.
Note
If projection was stopped by turning the power breaker
z
switch off and you turn the power breaker back on, the
<Power indicator> will light in green and projection will
) start again. (Only when the [INITIAL START UP] is set to
[LAST MEMORY] or [ON]. (
When the lamp has been cooled by the direct power off
z
function, it sometimes takes longer than usual for the
lamp to light up again.
While the cooling fan is operating, do not place the
z
projector inside a box or bag.
3)
page 54))
Æ