Select Settings - Fedders HFC1009N2F Installation And Operation Manual

SETTINGS

Select Settings

Your air conditioner has three adjustable settings:
Fan Speed, Swing (air direction), and Smart Air (memory)
Fan Speed setting
While the unit is running, press the Fan
Speed button to set the fan speed on low,
medium, high or auto.
When the auto fan setting is selected while
the air conditioner is in Cool mode, the fan
speeds will change automatically as the
temperature in the room changes
NOTE:
The fan setting is not applicable to
Dehumidify mode.
Swing (air direction) setting
You can direct the air flow from your air
conditioner into the room using the Swing
button. You can also continuously sweep
the air up and down.
Swing Button
• Turn on your air conditioner by pressing on
the Power On/Off button on the remote
control
• Press the Swing button to move the air
outlet adjustable louver between
horizontal and vertical positions
NOTE:
The default setting for cool and
dehumidify modes is horizontal and for
heat mode the default setting is vertical.
Smart Air (memory) setting
Allows you to save current preferred set-
tings into memory and reactivate them
with one button.
• Press the Power On/Off button to turn on
the unit
• Press the Mode button and select the
desired operation mode, temperature and
vane position
• Press the Smart Air button twice to save
the setting into memory. The display will
show "IF".
• To recall the saved setting, press the Smart
Air button once. There will be a five sec-
ond delay before the stored setting begins.
The chart below identifies the different fan
Remote keypad
speeds as they are displayed on the remote con-
trol and the indoor unit.
Fan Speed
Remote
display
Onboard
display
Remote keypad Remote display
Remote display
Remote keypad
16
Med Auto
Low High
Fan Fan
Fan Fan
Air outlet
adjustable louver
Onboard display