Security Settings - Supermicro X10SAT User Manual

4-6

Security Settings

This menu allows the user to configure the following security settings for the
system.
• If the Administrator password is defined ONLY - this controls access to the
BIOS setup ONLY.
• If the User's password is defined ONLY - this password will need to be entered
upon each system boot, and will also have Administrator rights in the setup.
• Passwords must be at least 3 and up to 20 characters long.
Administrator Password
Use this feature to set the Administrator Password which is required to enter the
BIOS setup utility. The length of the password should be from 3 characters to 20
characters long.
HDD Security Configuration
Use this feature to set the Hard Disk Drive Password which will be required to
access the selected hard disk drive. The length of the password should be from 3
characters to 20 characters long. To begin, use the cursor to highlight a detected
hard disk and press <Enter>. Press <Enter> again on "Set User Password" to
define the hard disk drive password. Save when finished.
4-31
Chapter 4: AMI BIOS