Dräger REGARD 7000 Instructions For Use Manual page 98

Operation
Parameter
Device serial num-
ber
Sensor name
Sensor part num-
ber
Sensor serial num-
ber
Startup inhibit time Time for which the channel is locked after switching on the
7.11.7.4 Parameter menu Fieldbus
This menu can be used to configure the fieldbus settings.
Parameter
Fieldbus slave ID
Slave Type
Device Index
7.11.7.5 Parameter menu Measurement
Information on the target gas can be recorded in this menu.
Parameter
Gas name
Short gas name
Measurement unit
Description
Serial number of the transmitter.
Sensor name of the sensor used in the transmitter.
Order number of the sensor.
Serial number of the sensor.
transmitter power supply voltage. This ensures that no
alarms are triggered during the warm-up phase of the trans-
mitter.
Adjustable range: 0 to 600 s
Description
Modbus address of the slave
Adjustable range: 1 to 247
Pre-configured slave type
Selection: None, Polytron 8100, Polytron 8200 LC, Polytron
8200 DD, Polytron 8310, Polytron 8700, Polytron 8720,
GS01 and ISA100 UAPMO)
Applies when multiple devices have the same Slave-ID (e.g.
via a gateway)
Note for ISA100 Gateway: the device index is used to deter-
mine the register address for DIAG_STATUS, PV_STATUS
and PV_VALUE. The registers must be assigned in this
sequence. For device index 1, the register address starts
from 100. The register addresses for the following device
indexes are expected every 20 registers (120, 140, 160, ...)
Description
Name of the target gas. Selection via dropdown list or text
input.
Target gas wizard
A Dräger transmitter can be selected with the device wizard.
The parameters are automatically assigned with the default
values of the target gas depending on the target gas. The
default values can be changed after closing the measured
gas wizard.
Short version of the name of the target gas.
Measurement unit of the target gas. Selection via dropdown
list or text input.