Dräger REGARD 7000 Instructions For Use Manual page 95

Channels can only be added if Overrange latching is activated.
If Overrange latching is deactivated, all added channels are automatically
removed from the list.
To add a channel:
1. Select
 A list of the channels is displayed according to the channel filter setting.
2. Select the required channels and confirm.
To remove a channel:
1. Enable the checkbox of the channel. If necessary, enable multiple channels for
removal.
2. Select
An input channel must only be used for acknowledgement of the over range of a
single measuring channel.
7.11.6.9 Inhibit parameter menu
In this menu various channels can be selected via which the current channel can be
inhibited.
A channel can be be inhibited at any time via the Dashboard.
To add a channel:
1. Select
 A list of the channels is displayed according to the channel filter setting.
2. Select the required channels and confirm.
To remove a channel:
1. Enable the checkbox of the channel. If necessary, enable multiple channels for
removal.
2. Select
7.11.6.10 Parameter menu Transmitter diagnostic (HART module only)
With the transmitter diagnostics activated, the correspondence of transmitter
parameters (configurable) with the parameter values set in the 4-20 mA Input /
HART module are checked. A warning is displayed in the event of deviations.
To suppress diagnostic warnings:
1. Enable Suppress diagnostic warnings checkbox.
To select the transmitter parameters where correspondence is to be checked:
1. Activate the checkbox of the desired transmitter parameters.
.
Possible preventive channel filter settings: Fitting channels, Available
channels, All channels
to remove all selected channels from the list.
.
Possible preventive channel filter settings: Fitting channels, Available
channels, All channels
to remove all selected channels from the list.
Operation