Dräger REGARD 7000 Instructions For Use Manual page 126

Fault elimination and messages
Faults and mes-
sages
Warning 8
Transmitter
Wrong
REGARD 7000
configuration
Measurement
range exceeded
Measurement
range underrun
Warmup Trans-
mitter
Transmitter
maintenance
Special state 1
Transmitter
Special state 2
Transmitter
Special state 3
Transmitter
Special state 4
Transmitter
Special state 5
Transmitter
Cause
- - - Transmitter emits the
Warning 8 message
according to the system
configuration, but is still
ready to measure
- - - Transmitter transmits
an unexpected warning
signal
- - - Measurement range
exceeded
- - - Readings below the
measurement range
- - x Transmitter in boot
phase and not ready to
measure.
- - x Transmitter in mainte-
nance mode or in boot
phase and not ready to
measure.
- - x Transmitter emits the
Special State Signal 1
according to the system
configuration and is not
ready to measure.
- - x Transmitter emits the
Special State Signal 2
according to the system
configuration and is not
ready to measure.
- - x Transmitter emits the
Special State Signal 3
according to the system
configuration and is not
ready to measure.
- - x Transmitter emits the
Special State Signal 4
according to the system
configuration and is not
ready to measure.
- - x Transmitter emits the
Special State Signal 5
according to the system
configuration and is not
ready to measure.
Remedy
Evaluate warning
according to the direc-
tions in the instructions
for use of the transmit-
ter and implement rem-
edy.
Reconfigure REGARD
7000 to detect dynamic
warning signals.
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a