Table of Contents
Advertisement
Error Messages
■ If the buzzer beeps and "U" and "number" are alternately displayed, check the following. By pressing
■
[Start], the operation will resume.
If the problem persists, pull out the opwer plug and contact your dealer for service.
●
●
Poor installation
Water cannot be drained.
Door lock malfunction.
Spin operation cannot be
performed.
Water cannot be supplied.
Abnormal water supply
When there are too many or
too little clothes, draining
cannot be proceeded.
Dry filter not installed
■ If "H" and "number" are alternately displayed, check the following.
■
Inspection is required.
※1: When adjusting the child safety setting, please turn off the machine and restart.
30
Are the fixing bolts for packaging at the rear side of the product removed?
●
●
→ ■ P ress power [off] to stop cycle. Please contact the dealer that you purchased the product
from to remove the fixing bolts.
Check the water drain hose, drain filter and drain outlet.
●
●
• Do not allow the tip of the hose to face up. • It is frozen.
• The water drain hose or drain outlet is
clogged with lint.
• It is crushed.
If the message is still displayed after checking the above, contact your dealer.
●
●
If the door is not closed.
●
●
→Close the door.
→If the door is closed, close the door after once opening the door.
If the door does not open.
●
●
→Press the centre of the door firmly.
Check the clothes condition.
●
●
• Many large items (Towel sheets, Judo uniform, etc.) → Reduce such large items.
• Many clothes → Detangle the clothes.
• Not many clothes → Add one or two bath towels.
The main unit is installed on an unstable location or inclined floor surface.
●
●
Check the water drain hose and drain outlet. (See the descriptions for "U11".)
●
●
Check the water supply pathway.
●
●
• The water faucet is not turned on.
• The water supply filter is clogged with dust. (P. 35)
• Water or water supply hose is frozen.
• The water supply is cut off.
• Is the water supply abnormal? (The water level is too high) When the water levelrs toohigh,
do not open the door, please dram the water first.
The possibility of having too many clothes
●
●
→ ■ P lease check whether this are too many clothes or if the
clothes are too wet.
→ During Dry, if the clothes are too wet, please select to
spinning individually or remove excessive clothes.
The possibility of cooling water not able to be discharged
●
●
during Dry
→ Press power [off] to stop the Dry cycle and confirm whether
there is abnormal situation occurring basing on the contents
in [U11].
→ After spinning, restart the Dry cycle.
Is the Dry filter properly installed? (P. 22)
●
●
→After cleaning and maintenance, be sure to install the Dry filter properly. After installation,
restart the operation.
Turn off the tap just to be safe. Check the displayed content (2-digit number after "H"), pull
●
●
out the power plug, and contact your dealer.
• Do not allow the tip to be soaked in water.
• Clean the drain filter if blocked. (P.23)
Turn off the power;
reselect the desired
cycle, restart the
operation. If the door is
locked, please release
the [Door lock] first.
(P. 16)
Advertisement
Table of Contents
