Table of Contents
Advertisement
7. Djust with balance adjustment chip (if necessary)
n Instruction for use of balance adjustment chip
1. Occasions
n When the bubble of the level gauge does not enter the internal standard
line, use it to select the level.
2. Situation of use
n If the back side of body is low and front side is high, select the height of
body by using balance adjustment chip on back feet.
n If the front side of body is low and back side is high, select the height of
body by using balance adjustment chip on front feet.
3. How to use the balance adjustment chip
n Select the proper height below basing on the tilt height.
(1)
Use single chip
(Use rubber gaskets)
(Adjustable height is 3mm)
8. Re-confirmation
1. Connect water
supply hose
2. Turn on the water tap
l Water tap must beturned
on even when Drying.
44
Place it under the foot of
the body.
(2)
Use 2 chips
(add plastic spacers to elevate)
(Adjustable height is 8mm)
※Note: Do not use plastic spacers alone.
3. Plug the power plug
4. Set the water-drain
tighten
loosen
If the knob is difficult to lock
after adjusting the level, insert
a cross screwdriver into the
knob hole and turn
counterclockwise, then it will
be tightened
Place it under the foot of
the body.
l Do not forget to
install the
ground wire.
hose to drain state.
Advertisement
Table of Contents
