Table of Contents
Advertisement
Door lock
The door will be locked during operation.
is displayed during operation. The door does not open.
<Open the door>
Pressing [Start/Pause] button during operation stops the drum rotation and cancels
●
●
the lock with clicking sound. The door does not open while the drum is rotating.
Note
• If the door is opened while washing, bubble may spill out. Receive it with a towel, etc.
(Water droplets may also fall from the inside the door.)
• With the Child Lock set, the door does not open even if the appliance is not operating.
• The door does not open while the Reserver is being set. Turn the power off, and make the setting again.
• Do not disconnect the power plug. The lock cannot be cancelled even if the power is turned off.
Setting Child lock
To prevent accidents of children, this function disables door opening even if the power is turned off or after the operation has finished.
■ How to set
※
1
Close the door and
turn the power on.
2
Press and hold for at
least 5 seconds.
The setting is complete when [Child lock] and
displayed after a double beep is heard.
Note
• When the power is turned on after Child Lock has been set,
The door is locked if the water temperature is high.
During operation, when the temperature inside the Wash tub is high, the door will be locked, and Door locked light will be on. Even if
you pause the operation or turn off the power, the door cannot be opened.
<To open the door immediately>
Turn the power off →
drum.)
Wash is not over. Please re-run.
●
●
The door will be locked when the temperature inside the Wash tub is high.
During Dry, when the temperature inside the Wash tub is high, the door will be locked. Even if you pause operation or turn off the
power, the door still cannot be opened.
Before the temperature drops, the door cannot be opened.
<To open the door immediately>
Turn the power off →
The cooling operation will start (5 to 25 minutes), and the draining and air blowing will lower the temperature inside the tank.
●
●
When the cooling is completed, there will a rattle sound, and the door will be locked.
●
●
※ Cooling time may vary depending on temperature inside the wash tub.
16
is
Turn the power on → Start [Spin] (Water supply may start to lower the water temperature inside the
Turn the power on →
press and hold for at least 5 seconds → [Fluffy] light is on
■ To cancel
※
1
Close the door and
turn the power on.
2
Press and hold for at
least 5 seconds.
The setting is complete when [Child lock] and
disappears after a double beep (x2) is heard.
is displayed for approx. 2 seconds each time.
is
Advertisement
Table of Contents
