Table of Contents
Advertisement
Troubleshooting
Symptom
Button does not work?
During cleaning and
maintaining, it is found that
the Dry filter is moisture
The door cannot be opened
Disturbing odour
Filter cleaning light flashing
non-stop
Not seeing water during Wash
No water
There is water but it is not
stored.
Supplying water midway
Drainage midway
After starting, you may press [Pause] and proceed with switch during the entire Wash. To
●
●
change cycle or contents after spinning, please restart the power.
When only [Door locked] display light is on and the buttons does not work, please release
●
●
the door lock and cool up the wash tub. (P. 16)
If the operation portion does not display [0], turn off the power and proceed with operation.
●
●
When setting the [Time (min)]
●
●
●
●
When setting a shorter Dry time or stopping the Dry midway, there may be moisture, but it is
not abnormal. Please hang to dry completely (to avoid generating mildew).
High temperature inside the wash tub
●
●
Door lock setting functioning. (P. 16)
●
●
Child safety lock setting functioning. (P. 16)
●
●
The appliance (rubber or resin) may smell after purchase for certain period. This smell will
●
●
disappear as time passes using the appliance.
Take out the clothes immediately after the operation has finished.
●
●
Clean the back side of the window seal. (P. 23)
●
●
Wash the drum. (P. 24)
●
●
Please clean the Dry filter, drain filter and push them back into their places after cleaning,
●
●
and the filter cleaning light will go off.
This is because the drum type Wash and Dry machine uses less water compared to
●
●
automatic Wash machine.
Did you forget to turn on the water faucet?
●
●
Is there a disruption of water supply?
●
●
Is the water supply hose blocked by dirty objects?
●
●
Please remove the water supply hose and clean the filter at the connection port of the water
supply hose. (P. 35)
When there is excessive foam, sometimes the water supply will temporarily stop.
●
●
Sometimes the machine does not store water and drain it immediately, so please do not
●
●
open the door or put hot water into the wash tub.
There may be a small amount of drainage when restarting.
●
●
If the water level drops, the water supply will be automatically started.
●
●
When the amount of clothes is high, the machine may supply water several times.
●
●
When there is too much foam, it will drain and supply water repeatedly to remove the foam.
●
●
Draining midway through [Wash] during the [Intensive] program can prevent dirt from
●
●
attaching onto clothes again.
Use tub detergents containing interface active agent and proceed with [Drum clean]
●
●
operation, then the foam may increase or drainage may happen midway.
There may be a small amount of drainage when restarting.
●
●
Cause
31
Advertisement
Table of Contents
