Table of Contents
Advertisement
The clothing are not completely dry.
Dry time is very long! But the clothes are not dry!
■ Are Dry filters showing the following
■
state?
Cotton-like dust is attached on the dry filter
●
●
→ R emove and clean the dry filter. (P. 22)
The dry filter is clogged. ([Filter cleaning] blinks.)
●
●
→ Even if the cotton-like dust is removed, the filter
may be still clogged.
Wash well with lukewarm water and dry.
Remove cotton-like dust attached on the dry
filter (inside) as well and wipe with a wrung-out
towel, etc.
Note
• When excessive foaming detergent is used or excessive detergent causes excessive foam, the bubbles in the drum may reach
the dry filter by spin rotation, causing the filter to be clogged or bubbles to spill over.
If the filter is clogged or the bubbles spill over, reduce the amount of detergent.
■ Amount of clothes and the condition
■
Too many clothes.
●
●
→ P ut in clothes of the upper limit amount or less according to the capacity of each
program. (P. 8)
There are many clothes (cotton) that need longer time to dry.
●
●
→Use Timer to dry more. (P. 21)
There are many thick clothes (jeans, sweat shirt, Judo uniform, etc.).
●
●
→Use [Intensived] to dry more. (P. 9)
The [Wash+Dry] operation is being performed with many towels in.
●
●
→ T owels stick to the drum during the [Spin] cycle, which interrupts drying process.
Perform the [Wash+Dry] operation with other clothes (20 to 30%) in.
Detangle the clothes after spin.
●
●
Do not put clothes in a laundry net.
●
●
The remaining time of Dry does not decrease or decrease
suddenly!
■ The displayed time is only estimated Normal value and is different from actual time.
■
Displayed time is the estimated required time for Dry. It automatically
●
●
adjusts basing on the type of clothes and the Dry state, so the displayed
time may be different from the actual Dry time.
If the Dry time is over 1 hour or does not decrease, it may be due to
●
●
blockage of Dry filter mesh or insufficient spinning time.
→The maintenance of Dry filter (P. 22)
The mesh is not
The mesh is
clogged
clogged
■ Others
■
Did you open the door
●
●
several times during the
operation?
→ Please minimize the
number of opening and
closing of the door.
When [Fluffy] is flashing,
●
●
it means [Dry Mode]
operation is completed.
→ Please open the door
and remove the clothes.
The room temperature is
●
●
too low and Dry cannot be
proceeded (under 5˚C)
The temperature of the
●
●
condensed water will
affect the clothes drying
effect.
29
Advertisement
Table of Contents
