Table of Contents
Advertisement
Troubleshooting
Symptoms
When the breaker trips (fuse /
protector trips)
Power outage
Turbid water when disruption
of water supply
Water supply hose is frozen
The water supply is
little
Check the following
Stop operation. It will not operate again even if the energy is back.
If the breaker trips during the Wash process, please identify the causes and take action,
●
●
then reset the breaker, press the power [on] to start operation again.
If the breaker trips during the Dry process, please identify the causes and take action, then
●
●
reset the breaker, press the power [on] to release the door lock. Restart operation after
cooling down. (P. 16)
The operation will stop, and it will not operation even after the energy is back. Please press
●
●
power [on] and reset to start operation (if the door cannot be opened P. 16)
After the disruption of water supply, there may be turbid water coming out. Please remove
●
●
the hose temporarily to let the turbid water completely comes out from the water faucet
before Wash again.
Heat up the connector, water supply hose and Wash tub with the following steps
●
●
1. Use hot
towel wrap
connecting
portion
Maintain the water supply filter with the following steps.
●
●
1. Turn off the faucet
2.
Turn on the power
Start → drain the water inside the hose after about 1 minute
3.
4.
Turn off the power
5. Loosen the nut
6. Remove the filter
7. Clean the filter
If you use well water → impurities, prone to debris accumulation, it needs regular cleaning.
●
●
(continued)
2. Remove the
menos de
water supply
50 grados
hose and
soak it in
warm water
Loosen the nut → Remove the filter → Clean the filter
soltar la rosca →sacar la red filtradora→ limpiar la red filtradora
3. Add 2-3L of
menos de
warm water
50 grados
in wash tub
35
Advertisement
Table of Contents
