Ppp/Mlppp Configuration Examples; Configuring A Bridged Ppp/Mlppp Link Example - Extreme Networks WM-4T1i WAN Installation And User Manual

Table 3-2: PPP/MLPPP Show Commands (continued)
Command
show ppp {<portlist>} {detail}
show accounts pppuser
1. To display alarm status for T3 links, use the
2. To display error statistics for T3 links, use the

PPP/MLPPP Configuration Examples

The following examples show how to configure multilink groups.

Configuring a Bridged PPP/MLPPP Link Example

The following example shows how to configure a BCP-encapsulated multilink group.
BCP is the default encapsulation, so it is not explicitly included in this example. While
only one VLAN is shown in this example, you may configure multiple VLANs across
the link. The
you might need to configure the T1 parameters for your link. Each T1 port in the
multilink group will have the same T1 and PPP configurations. If you change the
configuration for a single port, the change will affect the entire group.
WAN Module Installation and User Guide
config ports t1 clocksource
Description
Shows PPP configurations.
Show the PPP accounts on the switch.
show ports t3 alarms
show ports t3 errors
command is included to show where
PPP/MLPPP Configuration Examples
command
command
3-7