Wan Port Monitoring Commands - Extreme Networks WM-4T1i WAN Installation And User Manual

WAN Port Monitoring Commands

Table 2-2 describes the commands used to monitor a WAN port.
Table 2-2: WAN Port Monitoring Commands
Command
disable ports <portlist> [t1 | e1 | t3] loopback
enable ports <portlist> [t1 | e1 | t3] loopback
[local | network line]
enable ports <portlist> t1 loopback network
payload
enable ports <portlist> [t1 | t3} loopback remote
[line | payload | loopdown]
show ports {<portlist>} {t1 | e1 | t3} stats
show ports {<portlist>} [t1 | e1 | t3] alarms
show ports {<portlist>} [t1 | e1 | t3]
configuration
show ports {<portlist>} [t1 | t3] errors [near-end
| far-end] [totals | intervals | current]
show ports {<portlist>} e1 errors near-end
[totals | intervals | current]
show ports {<portlist>} [t1 | e1 | t3] info
WAN Module Installation and User Guide
Description
Disables the current loopback mode and return
to normal function.
Enables the near-end port loopback modes.
Enables the far-end T1 or T3 port loopback
modes and stops the loopback
Displays real-time port statistics.
Displays real-time port alarms.
Displays the port configuration and status.
Displays current and past errors.
Displays the port configuration and status.
Monitoring WAN Physical Links
2-13