Table of Contents
Advertisement
Configuring PPP and MLPPP
Table 3-1: PPP/MLPPP Configuration Commands (continued)
Command
restart multilink <groupname>
unconfig ppp port <portlist>
Monitoring PPP/MLPPP Links
The following commands monitor the status of the PPP and MLPPP links.
Table 3-2: PPP/MLPPP Show Commands
Command
show multilink <groupname>
show multilink [<groupname>] stats {detail}
show multilink [<groupname>] t1 alarms {detail} Displays T1 alarm status for multilink groups.
show multilink [<groupname>] t1 errors
[near-end | far-end] [totals | intervals | current]
show ppp {<portlist>} {detail}
show accounts pppuser
PPP/MLPPP Configuration Examples
The following examples show how to configure multilink groups.
Configuring a Bridged PPP/MLPPP Link Example
The following example shows how to configure a BCP-encapsulated multilink group.
BCP is the default encapsulation, so it is not explicitly included in this example. The
config ports t1 clocksource
to configure the T1 parameters for your link. Each T1 port in the multilink group will
3-6
Description
Restarts multilink group. Configuration changes
made to an enable multilink group will not take
effect until the group is restarted.
Resets the port to the default PPP
configuration; no authentication and BCP
encapsulation.
Description
Displays the configuration of the multilink
group.
Displays multlink group statistics.
Displays T1 error statistics for a multilink
group.
Shows PPP configurations.
Show the PPP accounts on the switch.
command is included to show where you might need
WM-4T1i Module Installation and User Guide
Advertisement
Table of Contents
