Source Setup; Enabling / Disabling Sources; Power On Source - PDi -P15LCDC-ARM User Manual

Source Setup

Enabling / Disabling Sources

The TV's signal sources can be individually Enabled or Disabled. A TV that is switched to a
non-connected source generates nuisance hospital maintenance calls of "TV Not Working",
when in fact the TV does work, but has been set to an inactive source. Please Disable all
of the TV's sources that are not to be used.
1. From the SETUP menu press the CH▲ / CH▼ button to select Source Setup. Then
press the VOL◄ / VOL► button to enter.
2. Press the CH▲ / CH▼ buttons to select a source.
3. Press the VOL◄ / VOL► buttons to change the source status to either Disabled or
Enabled as desired. NOTE: Sources that are grayed out are not installed in the TV.
4. Press the SETUP button to exit.

Power On Source

The TV can be preset to power on to a select source.
1. From the SETUP menu press the CH▲ / CH▼ button to select Source Setup. Then
press the VOL◄ / VOL► button to enter.
2. Press the CH▲ / CH▼ buttons to select Power Con Source.
3. Press the VOL◄ / VOL► button to change the source. NOTE: The source must be
enabled before it can be chosen as a power on source. The "LAST" entry causes the TV
to power on from the "LAST" source selected.
4. Press the SETUP button to exit.
43
Document Number: PD196-104 Rev 1