Before Requesting Service - Panasonic NU-SC180B Owner's Manual

Before Requesting Service

PROBLEM
No display on panel.
Oven cannot start
operation.
No steam.
"U14" appears in the
display window.
F0003CF00CP_09_EN_20210218.indd 47
POSSIBLE CAUSE
The oven is not plugged in securely.
Circuit breaker or fuse is tripped
or blown.
There is a problem with the outlet.
There is a problem with the oven.
The door is not closed completely. Close the oven door securely.
Start/Set button was not
pressed after programming.
Another program has already
been entered into the oven.
The program has not been
entered correctly.
Stop/Reset button has been
pressed accidentally.
Check whether the water tank
has water.
Check whether the integrated water
tank is installed correctly in place.
The water tank lacks water.
Even it is full of water, "U14" will
appears in the display window in
different conditions.
If it is not cleaned in time after "
" appears in the display window,
scale will accumulate around the
inner wall of the water-piping.
- Eng-47 -
REMEDY
Remove plug from outlet, wait 10 seconds
and re-insert.
Reinstall the fuse or reset the circuit
breaker.
Plug another appliance into the outlet to
check if the outlet is working.
Please contact the service center specified
by Panasonic.
Press Start/Set button.
Press Stop/Reset button to cancel the
previous program and program again.
Program again according to the operating
instructions.
Program oven again.
Fully fill the water tank and properly install it.
"U14" appears in the first two cooking
stages, you can refill water and press
Start/Set button to continue. It is not
available if "U14" appears in the third
time. Please fill the water tank with water
again. Replace to the oven and press
Stop/Reset to reset.
Please use the citric acid cleaning function
to clean the water-piping.
2021/2/27 10:33:37