Table of Contents
Advertisement
Using monitoring commands
Update:
Time Alive:
Time Awake:
ID:
Part Num:
Serial Num:
Revision Num:
Chassis Factory Serial Num: DZB1339A006
errDump and errShow
Use the errShow command to display device error log messages one at a time. Use the errDump command to display error log
messages without any page breaks. The output of these commands are unique for each Control Processor (CP), so must be executed on
each CP blade to obtain a complete record.
Following is a partial example of errDump output.
chassisX6:admin> errdump
2016/03/28-08:44:28,[FV-1001], 90, SLOT 1 CHASSIS,INFO,My_Switch,Flow Vision daemon initialized.
2016/03/28-08:44:51,[FSSM-1002],91,SLOT 1 CHASSIS,INFO,My_Chassis,HA State is in sync.
2016/03/28-08:44:51,[SULB-1003],92,SLOT 1 CHASSIS,INFO,My_Chassis,Firmwarecommit has started.
2016/03/28-08:48:27,[SULB-1004],93,SLOT 1 CHASSIS,INFO,My_Chassis,Firmwarecommit has completed.
2016/03/28-08:48:27,[SULB-1036],94,SLOT 1 CHASSIS,INFO,My_Chassis,The new Version: Fabric OS v8.0.1_bld52.
2016/03/28-08:48:27,[SULB-1002],95,SLOT 1 CHASSIS,INFO,My_Chassis,Firmwaredownload command has completed
successfully.
2016/03/28-08:50:51,[IPAD-1003],96,SLOT 1 CHASSIS,INFO,My_Chassis,DNS parameters saved successfully.
-------------------------------------------------------------------------------------------------------------
Note the following about this output:
•
The output can contain several thousand lines. Use errClear command to reset the output when needed. This command clears
all error log messages for all director instances on the CP where the command is issued.
•
My_Switch corresponds to what is entered for switchname and is a switch or logical switch event.
•
My_Chassis corresponds to what is entered for chassisname and is a chassis event.
fanShow
Use this command to display the current status and speed of each installed fan. The following is an example of fanShow output.
chassisX6-4:admin> fanshow
Fan 1 is Ok, speed is 6993 RPM
Fan 2 is Ok, speed is 6993 RPM
haShow
Use this command to display the control processor (CP) status. The display includes the following information:
•
Local CP state (slot number and CP ID), warm or cold, recovering or recovered.
•
Remote CP state (slot number and CP ID).
•
High Availability (enabled or disabled).
118
Day:
0
Month:
0
Year: 0
24 days
0 days
***(@*%)(*
***(@*%)(*@#%(@*%)@*
***(@*%)(*@#%(@*%)@*
***(
Brocade X6-4 Director Hardware Installation Guide
53-1004106-07
Advertisement
Table of Contents
