Brocade Communications Systems X6-4 Hardware Installation Manual page 199

3. Pull out the spring-loaded latch release at each end of the cover and slide each latch towards the end of the cover.
This should slide the latches into the chassis and lock the panel in place. If not, the cover may not be seated fully into the slot.
Try unlatching both ends, pushing the cover firmly into the slot, then latching both ends again.
NOTE
Be sure filler panels are securely latched. If not, high pressure from fan operation may unseat blade from chassis
connectors.
FIGURE 74 Removing and installing the blade filler panel
1. Latch pull tab
4. Reinstall the chassis door. The door must be installed to meet EMI compliance.
Brocade X6-4 Director Hardware Installation Guide
53-1004106-07
2. Latch release
Installing a filler panel
199